RAD ASMi-52 Specifications Page 97

  • Download
  • Add to my manuals
  • Print
  • Page
    / 144
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 96
Installation and Operation Manual Appendix E IR-ETH/Q Ethernet Card
ASMi-52CD Ver. 1.0 Installation and Operation E-3
E.2 Technical Specifications
General
LAN Table
2,000 addresses
Buffer
200 kbytes
LAN
Standard
Conforms to IEEE 802.3/Ethernet and
supports IEEE 802.1/Q frames
Data Rate
10 Mbps (20 Mbps 10BaseT FDX)
Connectors
10BaseT (UTP): Shielded RJ-45
WAN
Protocol
HDLC
Data Rate
According to the modem transmission rate
Connector
RJ-45
E.3 Installation and Operation
This section describes:
IR-ETH/Q Ethernet card installation on the ASMi-52CD modem module
LRSI-F-14 interface module installation in the LRS-24 hub
For hub installation and operation of the ASMi-52CD module, see
Chapter 2
.
The ASMi-52CD and IR-ETH/Q cards contain components sensitive to electrostatic
discharge (ESD). To prevent ESD damage, do not touch the module components
or connectors.
Installing IR-ETH/Q Card
To install the IR-ETH/Q Ethernet card:
1. Set the DIP switch on the IR-ETH/Q Ethernet card according to
Table E-1
.
2. Press the IR-ETH/Q Ethernet card (with connectors facing down) against the
ASMi-52CD module connectors.
Installing Interface Module
Check that the LRSI-F-14 interface module (or LRSI-B-14), shown in
Figure E-3,
was supplied. The fuses are shown in
Figure E-4
.
Caution
Page view 96
1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 143 144

Comments to this Manuals

No comments