RAD ASMi-52 Specifications Page 49
- Page / 144
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
ASMi-52CD Ver. 1.0 Introduction 5-1
Chapter 5
Troubleshooting and
Diagnostics
This chapter describes the ASMi-52CD diagnostic functions, which include:
• Diagnostic tests:
Loopback tests for ASMi-52CD/4 with synchronous and E1 interfaces
LED test
• Status indications and alarms
• SHDSL performance diagnostics
• Troubleshooting procedures.
5.1 Introduction
ASMi-52CD offers diagnostics for troubleshooting:
• Loopback – Tests the performance of the local modem and either the remote
modem or the local DTE, and the lines connecting them. (Serial interfaces
only.)
• Alarm buffer – Contains alarm messages regarding the status of the
transmission system
• SHDSL statistics collection
All diagnostics options can be performed using RADview SNMP management tool
or an ASCII terminal. Then, examine the alarm buffer messages for any
transmission error or configuration mismatch. When you set a test for one
modem of ASMi-52CD, no parameters for this modem can be changed except to
disable the specific test. Once the line is disconnected, or one of the units is
reset, the diagnostics stop.
For ASMi-52CD/4 with E1 interface in all diagnostics functions the clock mode
remains unchanged in order to avoid interfering with the other channels.
Note
- ASMi-52CD 1
- Limited Warranty 4
- Product Disposal 4
- Safety Symbols 5
- General Safety Instructions 5
- Handling Energized Products 6
- Attention 8
- FCC-15 User Information 9
- Quick Start Guide 11
- Configuring the Clock Source 12
- Contents 15
- Chapter 1 17
- Central Site 18
- Remote Site A 18
- Remote Site B 18
- Data Rate 19
- Remote Management 20
- 1.2 Physical Description 21
- Figure 1-4 23
- Figure 1-4) 23
- Table 1-5 23
- 1.3 Functional Description 24
- 1.4 Technical Specifications 25
- Chapter 2 27
- Installation and Setup 27
- 2.2 Package Contents 28
- Figure 2-2 29
- Warning 29
- Interface Module Inspection 30
- LRSI-F-24 31
- LRSI-F-25 31
- Figure 2-5 32
- Connecting the Line and DTE 33
- Figure 2-6. LRSI-F-5 34
- Figure 2-7. LRSI-F-14 35
- Figure 2-8. LRSI-F-23 36
- Chapter 3 39
- Operation 39
- Figure 3-1. ASMi-52CD LEDs 40
- ASMi-52CD 4-Wire 41
- 3.3 Turning Off 42
- Chapter 4 43
- Configuration 43
- Table 4-1. LRS-24 Screens 44
- Figure 4-1 44
- Table 4-2 45
- 4.4 Configuring the Modem 46
- Configuring the E1 Interface 47
- Chapter 5 49
- Troubleshooting and 49
- Diagnostics 49
- Figure 5-1 50
- Table 5-1 50
- Running Loopback Tests 52
- Running the LEDs Test 53
- Figure 5-4 54
- Figure 5-5 54
- Figure 5-6 54
- Table 5-3 57
- Table 5-4 57
- Table 5-5 57
- 5.5 Troubleshooting 60
- 5.7 Technical Support 61
- Appendix A 63
- Pinouts 63
- A.2 LRSI-F-14 64
- A.3 LRSI-F-23 65
- Figure A-4. LRSI-F-24 66
- Figure A-5. LRSI-F-25 67
- Appendix B 69
- Memory and Download 69
- B.2 Download Procedure 70
- Downloading via LAN 71
- Downloading via XMODEM 71
- Downloading via CM-2 Flash 72
- Figure B-7 73
- Appendix C 75
- List of Parameters 75
- Figure C-2 76
- Table C-2 76
- Table C-2. Modem Setup 79
- C.3 Displaying Modem Status 83
- Figure C-7 87
- Appendix D 89
- IR-ETH Ethernet Card 89
- Setting the DIP Switch 90
- General 91
- Installing Interface Module 92
- D.4 Connections 93
- Appendix E 95
- IR-ETH/Q Ethernet Card 95
- DIP Switch Settings 96
- E.2 Technical Specifications 97
- E.4 Connections 99
- Pin Assignment 100
- Appendix F 101
- IR-ETH/QN Ethernet/Fast 101
- Ethernet Card 101
- F.2 Application 102
- F.3 Technical Specifications 102
- Configuring IR-ETH/QN 103
- Installing IR-ETH/QN Card 105
- LED Indicators 106
- Fault Propagation 107
- Appendix G 109
- IR-IP Interface Card 109
- Application 110
- Physical Description 110
- G.2 Technical Specifications 111
- Cabling 112
- IR-IP LEDs 113
- Introduction 114
- Rescue Configuration 115
- Connecting the Telnet Host 116
- What to Do If 116
- General Operating Procedures 117
- Figure G-4. IR-IP Main Menu 118
- Figure G-5 118
- G.7 Quick Setup Menu 119
- WAN IP Address 120
- WAN IP Mask 120
- Default Gateway 120
- DHCP Relay 121
- Protocol 121
- G.8 Management Access Menu 122
- G.9 Advanced Setup Menu 123
- Interface Parameters Menu 124
- Quick Setup Menu 125
- Figure G-6 125
- Protocol Field Compression 126
- Authentication Protocol 126
- Multicast IP Menu 127
- Multicast Forwarding 128
- Static Groups 128
- G.10 Device Control Menu 129
- View Error Log Screen 130
- Erase Configuration 131
- Resets Menu 131
- G.11 View Menu 132
- Configuration and Connection 133
- ARP Tables 133
- Statistics Screen 134
- Using the Ping Function 136
- Customer Response Form 139
- Error Report 141
- Innovative Access Solutions 144
Related products and manuals for Networking RAD ASMi-52
Networking RAD ASMi-54 Specifications
(64 pages)
(64 pages)
© 2020, manymanuals.com. All rights reserved. | 0.788 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals