RAD ASMi-52 Specifications Page 93
- Page / 144
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Installation and Operation Manual Appendix D IR-ETH Ethernet Card
ASMi-52CD Ver. 1.0 Connections D-5
IR-ETH LED Indicators
Table D-2
lists the IR-ETH LED functions and describes their functions.
Table D-2. IR-ETH Bridge LED Indicators
LED Name Description Color
INT ON – Good link integrity Green
ACT ON – Data is received from the Ethernet attached segment
or data is transmitted from the modem to the Ethernet
segment
Yellow
Installing the Interface Module
To install LRSI-F-14 into the LRS-24 hub:
1. Insert the LRSI-F-14 module in the upper section of the LRS-24F chassis
above the module, or the back section of LRS-24B.
2. Fasten the screws to secure the module to the LRS-24 frame for good
grounding of the module panel.
D.4 Connections
For IR-ETH card installation either a straight or a cross cable may be required to
connect the LRSI-F-14 DCE-1 (DCE-2) connector to the LAN. Use a cross cable
when connecting to a port that does not implement the crossover function
internally. Otherwise, use a straight cable.
Hubs usually do implement the crossover function internally while NICs and other
devices do not.
Use
Table D-3
for the pin assignment of the IR-ETH RJ-45 connector needed
when preparing the LAN cable. For the pin assignment of the LRSI-F-14 line
connector, see
Chapter 2
.
Table D-3. Pin Assignment of Ethernet RJ-45 Connector
Pin No. ID Function Direction
1 Tx+ Transmit – positive lead Output
2 Tx– Transmit – negative lead Output
3 Rx+ Receive – positive lead Input
4, 5 – Not connected. –
6 Rx– Receive – negative lead Input
7, 8 – Not connected. –
Note
- ASMi-52CD 1
- Limited Warranty 4
- Product Disposal 4
- Safety Symbols 5
- General Safety Instructions 5
- Handling Energized Products 6
- Attention 8
- FCC-15 User Information 9
- Quick Start Guide 11
- Configuring the Clock Source 12
- Contents 15
- Chapter 1 17
- Central Site 18
- Remote Site A 18
- Remote Site B 18
- Data Rate 19
- Remote Management 20
- 1.2 Physical Description 21
- Figure 1-4 23
- Figure 1-4) 23
- Table 1-5 23
- 1.3 Functional Description 24
- 1.4 Technical Specifications 25
- Chapter 2 27
- Installation and Setup 27
- 2.2 Package Contents 28
- Figure 2-2 29
- Warning 29
- Interface Module Inspection 30
- LRSI-F-24 31
- LRSI-F-25 31
- Figure 2-5 32
- Connecting the Line and DTE 33
- Figure 2-6. LRSI-F-5 34
- Figure 2-7. LRSI-F-14 35
- Figure 2-8. LRSI-F-23 36
- Chapter 3 39
- Operation 39
- Figure 3-1. ASMi-52CD LEDs 40
- ASMi-52CD 4-Wire 41
- 3.3 Turning Off 42
- Chapter 4 43
- Configuration 43
- Table 4-1. LRS-24 Screens 44
- Figure 4-1 44
- Table 4-2 45
- 4.4 Configuring the Modem 46
- Configuring the E1 Interface 47
- Chapter 5 49
- Troubleshooting and 49
- Diagnostics 49
- Figure 5-1 50
- Table 5-1 50
- Running Loopback Tests 52
- Running the LEDs Test 53
- Figure 5-4 54
- Figure 5-5 54
- Figure 5-6 54
- Table 5-3 57
- Table 5-4 57
- Table 5-5 57
- 5.5 Troubleshooting 60
- 5.7 Technical Support 61
- Appendix A 63
- Pinouts 63
- A.2 LRSI-F-14 64
- A.3 LRSI-F-23 65
- Figure A-4. LRSI-F-24 66
- Figure A-5. LRSI-F-25 67
- Appendix B 69
- Memory and Download 69
- B.2 Download Procedure 70
- Downloading via LAN 71
- Downloading via XMODEM 71
- Downloading via CM-2 Flash 72
- Figure B-7 73
- Appendix C 75
- List of Parameters 75
- Figure C-2 76
- Table C-2 76
- Table C-2. Modem Setup 79
- C.3 Displaying Modem Status 83
- Figure C-7 87
- Appendix D 89
- IR-ETH Ethernet Card 89
- Setting the DIP Switch 90
- General 91
- Installing Interface Module 92
- D.4 Connections 93
- Appendix E 95
- IR-ETH/Q Ethernet Card 95
- DIP Switch Settings 96
- E.2 Technical Specifications 97
- E.4 Connections 99
- Pin Assignment 100
- Appendix F 101
- IR-ETH/QN Ethernet/Fast 101
- Ethernet Card 101
- F.2 Application 102
- F.3 Technical Specifications 102
- Configuring IR-ETH/QN 103
- Installing IR-ETH/QN Card 105
- LED Indicators 106
- Fault Propagation 107
- Appendix G 109
- IR-IP Interface Card 109
- Application 110
- Physical Description 110
- G.2 Technical Specifications 111
- Cabling 112
- IR-IP LEDs 113
- Introduction 114
- Rescue Configuration 115
- Connecting the Telnet Host 116
- What to Do If 116
- General Operating Procedures 117
- Figure G-4. IR-IP Main Menu 118
- Figure G-5 118
- G.7 Quick Setup Menu 119
- WAN IP Address 120
- WAN IP Mask 120
- Default Gateway 120
- DHCP Relay 121
- Protocol 121
- G.8 Management Access Menu 122
- G.9 Advanced Setup Menu 123
- Interface Parameters Menu 124
- Quick Setup Menu 125
- Figure G-6 125
- Protocol Field Compression 126
- Authentication Protocol 126
- Multicast IP Menu 127
- Multicast Forwarding 128
- Static Groups 128
- G.10 Device Control Menu 129
- View Error Log Screen 130
- Erase Configuration 131
- Resets Menu 131
- G.11 View Menu 132
- Configuration and Connection 133
- ARP Tables 133
- Statistics Screen 134
- Using the Ping Function 136
- Customer Response Form 139
- Error Report 141
- Innovative Access Solutions 144
Related products and manuals for Networking RAD ASMi-52
Networking RAD ASMi-54 Specifications
(64 pages)
(64 pages)
© 2020, manymanuals.com. All rights reserved. | 0.711 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals